Why We Test Every Single Lamp (And Why It Matters for Your Fab) When you’re running fab drying, you’re juggling high-wattage heat and...

Stop the Shatter: Keeping Your Fab Clean When Things Go Wrong Let’s be honest. When an IR lamp pops in a high-load fab, it’s a nightmare. It...

Keeping it Clean: Heating for Class 100 Cleanrooms When you’re working in a Class 100 environment, one tiny flake of dust is a disaster. Just...

If you’re running a Class 100 cleanroom, you already know the drill: one tiny speck of dust and your wafer yields tank. It’s a nightmare....

Dealing with Thermal Bleed in the Fab Ever touched the side of a piece of equipment and practically burned your hand? That’s the problem with...

Keeping Your Heater Housings Safe (And Your Gear Running) We build our stainless steel heater housings to take a beating from high heat, but...

Keeping Your Lamps from Blowing Things Up in Chemical Zones Let’s be honest: putting an infrared (IR) heating lamp in a room full of explosive...

On the lithography floor, a soft bake that drifts even half a degree can throw off critical dimension bias and wipe out a whole lot. You need heat...

On the line, the temperature curve isn’t a suggestion—it’s the process. In an LCD panel fab, the photoresist stack, substrate temperature, and bake...